Configuration - IDEC HR6S-DN Instruction Manual

Configuration and Commissioning

Configuration

Overview
The device detects certain technically incorrect configurations (for example, a configured start
function cannot be used with a configured application function). The device cannot detect
unwanted configurations (for example, automatic start has been configured, but a monitored start
is required for your application as a result of your risk assessment).
INEFFECTIVE SAFETY-RELATED FUNCTION AND/OR UNINTENDED EQUIPMENT
OPERATION
Only modify the settings of the selectors of the device if you are fully aware of all effects of

such modifications.
Verify that the settings of the selectors match the intended safety-related function and the

corresponding wiring of the device.
Verify that modifications do not compromise or reduce the Safety Integrity Level (SIL),

Performance Level (PL), and/or any other safety-related requirements and capabilities defined
for your machine/process.
Commission the device before it is used for the first time and after each configuration

according to the instructions in the present manual and in compliance with all regulations,
standards, and process definitions applicable to your machine/process.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
The device is configured by means of the application function selector and the start function
selector.
The device must be installed and wired according to the requirements of the safety-related function
to be implemented before you can configure it.
Modifications to the positions of the selectors only become effective after power-up. Remove
power from the device before modifying the position of the selectors. If the positions of the
selectors are modified while power is applied to the device, the device detects a configuration error.
Go through the full commissioning procedure
the selectors.
80
WARNING
(see page 82) after having modified the positions of
HR9Z-B2200 8/2020