Figure 6-13 Add Ip/Mac; Table 6-7 Add Ip/Mac Configurations - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide

Figure 6-13 Add IP/MAC

Table 6-7 Add IP/MAC Configurations

Parameter
Rule Type
Device All Ports
Device Start Server
Port
Device End Server
Port
Enable PING prohibited/Prevent Semijoin and click Save. You
Note
do not need to configure parameters.
5. Click OK, and the Firewall interface is displayed.
Click Save.
6.
46
Function
Select IP address, IP segment, MAC address or all IP
addresses.
• IP address: Select IP version and enter the IP address of the
host to be added.
• IP segment: Select IP version and enter the start address
and end address of the segment to be added.
• MAC address: Enter MAC address of the host to be added.
• All IP addresses: Set all IP addresses in allowlist or
restricted list.
Set access ports. You can select all ports or the ports in defined
areas.
• Device all ports: Set all IP port in allowlist or Blocklist. When
selecting BlocklList in Mode, and All IP Address in Rule
Type, you cannot select the Device All Ports check box.
• Device start server port and Device end server port: Set
Device start server port and device end server port, and the
range is 1–65535.