Honeywell Performance Series User Manual page 39

Performance Series IP Camera Software Configuration Guide
Gamma
Adjusts dynamic range. Choosing a higher value increases the brightness of the image non-
linearly. Select from 0 to 100. The recommended range is between 40 and 60. The default
value is 50.
Mirror
Select ON to switch the video from left to right. This function is disabled by default.
AOV
0° (Normal): This is the default setting.
90° (Flip Mode 1): Rotates the video by 90°.
180° (Inverted): Rotates the video by 180°.
270° (Flip Mode 2): Rotates the video by 270°.
Exposure
In the Exposure field, you can set the anti-flicker mode, exposure mode, auto iris, and digital
noise reduction level.
Anti-Flicker
This setting helps reduce flicker in the image. Select from Outdoor, 50 Hz and 60 Hz
according to your environment.
Outdoor: Minimizes flicker in outdoor applications. Works with auto, low noise, low motion
blur, and manual exposure modes
50 Hz: Minimizes flicker in indoor applications where the AC frequency is 50 Hz (generally
PAL regions). Works with auto and manual exposure modes
60 Hz: Minimizes flicker in indoor applications where the AC frequency is 60 Hz (generally
NTSC regions). Works with auto and manual exposure modes.
Mode
Select an exposure mode from Auto, Gain Priority, Shutter Priority and Manual.
Auto: The camera automatically sets the gain value and shutter speed.
Gain Priority: You set a gain value and the camera sets the proper exposure by assigning an
appropriate shutter speed.
Shutter Priority: You set a shutter speed and the camera sets the proper exposure by
assigning an appropriate gain.
Manual: Maximum shutter speed and maximum gain for normal light conditions are set by the
user.
3DNR
This setting reduces noise and retains good video quality in low light conditions. It is enabled
by default.
Grade
This value ranges from 0 to 100. The default value is 50 when 3D NR is on.
24