Figure 7-1 Motion Detection
Table 7-1 Motion Detection Configurations
Parameter
Function
Enable
Check to enable Motion Detection.
The camera Motion Detection function is activated during the specified
period.
See
Configuring the Alarm Period
Period
You can configure up to six periods per day. Select a date. If you do not
select a date, the current setup will be applied to today only. You can
select All to apply the alarm period to the whole week.
Click Save to exit.
Enter the anti-dither time in seconds. Enter a value between 0 and 100
Anti-Dither
seconds. The system will only allow one motion detection event within
this period.
Configure the motion detection region, its sensitivity, and area. The
Area
default settings covers the entire area. Click Save to enable these
settings. See
Record
If Record is enabled, a scene change event can activate recording.
The system will wait for the specified time before it begins recording.
Record Delay
Select from 10s to 300s.
Relay-out
Select the Relay-out check box, and when alarm is triggered, the system
on page 51.
Configuring the Motion Detection Area
Configuring Video Analytics Settings
on page 53.
51