Filtering IP/MAC Addresses
You can configure IP filter settings on the Setup > Network Setup > IP Filter page.
When the IP filter is enabled, remote access to the camera is restricted to specific IP or MAC
addresses. You can add or remove addresses from the list at any time. If a user is accessing
the camera over a WAN, enter the MAC address of the user's router instead of an IP address.
Adding IP/Mac Addresses to the List of Approved Users
To add an IP/MAC address:
1.
2.
3.
Click Add IP/MAC.
In the Add IP/MAC window, select IP Address, IP Segment, or MAC from the
drop-down list, enter the relevant address, and then click Save.
The address is added to the list of approved users.
Select the Approved Users check box, and then click Save to apply the settings.
Configuring Network Settings
33