Version With Integrated Handwheel (Only Hpw Version) - GEM CleanStar C60 HPW Installation, Operating And Maintenance Instruction

2. Screw in the hexagon nut which is
located under the transparent cap
clockwise as desired using a suitable
socket wrench.
3. Put on transparent cap again.
C60
11.6 Version with integrated
handwheel (only HPW
version)
The special version in actuator size 2 is
equipped with an extended stroke limiter.
With this special version the stroke limiter
can be set externally via the handwheel.
With control function 1 the open valve
can be closed with the handwheel. When
the valve is closed the opening stroke is
reduced and thus a preselected flow rate
set.
In normal condition the handwheel is locked
in place. Pull the handwheel upwards
for operation (disengage the lock). After
operation push it down over the locking disc
(fix the lock).
The version with handwheel was designed
for panel mounting.
If required, you will receive separate
instructions on setting the stroke limiter /
operating the handwheel via the address on
the last page.
Handwheel
Locking disc
Twist
protection
40 / 48
Disengage the lock
Fix the lock
Nut for panel
mounting
Connector 4
Connector 2