Operating Instructions; Power Up; Ettan Ipgphor 3 Control Panel - GE Ettan IPGphor 3 Instrument User Manual

Hide thumbs Also See for Ettan IPGphor 3:

Table of Contents

Operating instructions

Ettan IPGphor 3 Instrument User Manual 11-0034-58 Edition AB

The following sections will guide you through each stage of the isoelectric

focusing process using the Ettan IPGphor 3.

3.1

Turn on the mains power switch (|) located on the rear panel.

This activates a self diagnostic program that runs for approximately 10

seconds. A series of screens indicate progress. If any component fails, the

diagnostic program will stop and a message will indicate the source of the

fault; note the fault and press the START key to skip to the next test. If any

failure is detected, call GE Healthcare service.

WARNING! In a situation where there is a risk of injury, turn off the instrument

by switching the mains power switch (located on the rear panel) to position 0.

Malfunctions must be rectified before the Ettan IPGphor 3 is restarted.

3.1.1

Once the diagnostic program is successfully completed, the main screen

indicates that the instrument is ready, as shown below.

Ettan IPGphor 3

P r o t # 1 F i l e 1

R e h y d r a t e 0 : 0 0 H r @ 2 0 ˚ C

I E F @ 2 0 ˚ C 5 0 µ A / S t r i p

1 S t r i p s 0 S t e p s

Fig 3-1. Ettan IPGphor 3 control panel.

Operating instructions

Mains power

switch

Table of Contents