Operation - Wolf Garten GS 10 eM Manual

EN
Attention!
The power pack is supplied partially charged. Be-
fore using the device for the first time, fully charge
the power pack to ensure effective performance.
The power pack is permanently installed in
the operating arm.
The power pack must be charged in accordance
Î
with the instructions in the supplementary docu-
mentation.
Adjusting the working angle A B
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Before any work on the device, remove
the operating arm with the permanently
installed power pack beforehand.
The device can be set in any of seven different
working angles. This allows you to easily reach
problematic and difficult-to-access positions in the
garden.
Horizontal adjustment A
Press and hold the locating button 1 .
Î
Set the working angle 2 .
Î
Release the locating button.
Î
3 The locating button of the grass shears engages
audibly.
Vertical adjustment B
Pull the head of the grass shears [A] out in a
Î
forward direction and hold it 1 .
Turn the head of the grass shears through 90° to
Î
the left or right 2 .
Guide the head of the grass shears slowly back
Î
until it engages in position 3 .
3 The head of the grass shears engages audibly.
Note
The vertical position is, for example,
required for cutting flower bed borders
where there is no vertical edge, etc..
Connecting the grass shears to the operating
arm C
Press the locking button [A] on the operating arm
Î
and insert the operating arm into the locator of the
grass shears until the locating button [B] engages
12 .
22
CAUTION!
WARNING!
Attention!
¾ Ensure the button is correctly engaged
Note
A middle handle is available as an optional
accessory for the operating arm. You can
find more information and assembly instruc-
tions in the operating manual for the
operating arm.

Operation

Operating times
Please observe the times stipulated in local bye-
laws. Check with your local authorities to determine
if there are any operating time limitations.
Switching on the device D
Risk of injuries or material damage
¾ During operation, always hold on to the
device with both hands. One hand holds
the handle, the other hand holds the
operating arm in the encased area or the
optionally available middle handle.
¾ Always ensure you are standing safely.
Remove the protective cover.
Î
Press the lock-on switch [A] on the handle 1 .
Î
Simultaneously press the on/off switch [B] on the
Î
handle 2 .
Release the lock-on switch.
Î
3 The device operates.
Switching the device off D
Release the on/off switch on the handle.
Î
3 The device is switched off.
Note
The cutting tool continues to run for a brief
period after being switched off.
Note
The lock-on switch automatically returns to
its initial position when you release the on/off
switch.
Cutting E
Hold the device in the work position.
Î
Always guide the grass shears with the wheels on
Î
the ground.
Ensure a correctly set working angle so that the
Î
cutting tool does not cut into the ground.
Work slowly and carefully.
Î
Do not cut the lawn too close to the ground.
Î
WARNING!
Operation