Operation; Maintenance; Faults And How To Remedy - Wolf Garten UV 30 EV Instruction Manual

Operation

ssembly of cable relief holder (Fig. B1/B2/B3)
Connecting to the mains
The mower operates from any normal household mains supply (230 Volts, . C., 50 Hz), provided with a 13 mps. fuse.
Note: Use a residual current device (RCD) rated for a residual current not greater than 30 m .
djust operating depth (Fig. B4)
Only with motor switched off and non-mowing aeriating roller. The operating depth must be adjusted to the corresponding grass and
ground conditions.
• Move operating lever towards front.
• djust operating depth with turn handle to the desired depth (+).
eriating test:
- Pull operating lever up again.
- Start tool.
- Push operating lever slowly forward.
- Move tool slowly into operating direction.
- On hearing stones being hit or blocking of the motor immediately switch off tool.
- Turn rotating handle 1–2 rotations towards the left (–) - (One revolution corresponds to 1,5 mm.)
- Start aeriating test again.
• When used regularly the aeriating depth may be adjusted according to the wear of the blade (+).
Recommended working heights:
Lawn condition
well kept lawns with stone-free, soft ground
stony, untidy lawns
unkempt, extremely mossy lawns
Starting up the engine/Scarifying (Fig. B5/B6/B7)
1. Depress button (1) and hold
2. Lift up bar (2) and release button (1).
3. Place lever (3) slowly into forward position.
4. Switch-off motor: Release bar (2).
Important: Place the cable firmly off the lawn or on the already cut side of the lawn when starting to mow.
Turning (UV 30 EV, Fig. B1, UV 32 EV Fig. B8).
The cable relief holder enables you to move the cable from one side of the handle frame to the other. Thus you ensure that the cable
always trails on the ride of the lawn already cut – and not in front of the machine.
ttach grassbox* (Fig. M8)
Lift protective flap, hook grassbox with the hooks provided into the holes in the chassis (see arrow), reattach protective flap.
*Grassbox TK-VV 3632 060 - (accessory, available at additional cost)

Maintenance

Maintenance
Remove spark plug/mains plug cap before attemting any work to the unit.
Clean the unit thoroughly with a brush after each use. Do not spray with water. Store unit in a dry room.
We recommend
llow a WOLF-service centre to check the unit in the autumn.

Faults and how to remedy

Problem
No scarification result
Machine runs unevenly, with heavy
vibrations
bnormal noises or rattling in the
machine
Motor will not run
When in doubt, always consult a WOLF service workshop.
Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.
Working position
Set tool exactly to ground height
Set tool to ground height
• Increase working height if stones are thrown up
• Start with a high working height
• Do not overload appliance (increase working height if motor blocks)
• Cut vertically and crossways several times
• Re-sow with WOLF >>Loretta<< lawn seeds
Possible Cause
• The working depth is set too low
• Blade is damaged due to contact with hard objects
• Screws are loose
• Fuse blown
• Cable damaged
Important! If you inadvertently cut through the cable, the fuse (16 mp.) will
not always blow. In the interest of safety, never touch damaged or servered
cables before disconnecting the mains plug. Repairing the cable with insu-
lating tape is prohibited.
9
Remedy (X) by:
WOLF
Your-
Service-
self
Worshop
--- X
X ---
--- X
--- X
X ---