NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Align the sensor board on the display-panel assembly and snap the sensor board in place.
2. Slide the sensor-board cable into the connector on sensor board and press down the latch to secure the cable.
3. Adhere the tape that secures the sensor-board cable to the sensor board.
4. Replace the screw (M2x2 Big Head) that secures the sensor board to the display-panel assembly.
Post-requisites
1. Follow the procedure from step 6 to step 8 in
2. Replace the
display
assembly.
3. Replace the
wireless
card.
4. Replace the battery.
5. Replace the
base
cover.
82
Replacing the sensor board
Replacing the sensor board
computer. After working inside your computer, follow the instructions in
"Replacing the display
panel".
50
After
www.dell.com/