Replacing the power and volume-buttons
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Align the screw hole on the power and volume-buttons board with the screw hole on the palm-rest assembly.
2. Replace the screw (M2x3) that secures the power and volume-buttons board to the palm-rest assembly.
3. Route the power and volume-buttons board cable through the routing guides on the palm-rest assembly.
4. Connect the power and volume-buttons board cable to the I/O board.
5. Adhere the tape that secures the power and volume-buttons board cable to the palm-rest assembly.
Post-requisites
1. Replace the
coin-cell
battery.
2. Replace the battery.
3. Replace the
base
cover.
computer. After working inside your computer, follow the instructions in
Replacing the power and volume-buttons board
30
board
After
www.dell.com/
51