Replacing The Sensor Board - Dell Inspiron 13 5000 Service Manual

Replacing the sensor board

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1 Align the screw hole on the sensor board to the display panel and snap the
sensor board in place.
2 Slide the sensor-board cable into the slot on sensor board and press down the
latch to secure the cable.
3 Adhere the tape on the sensor-board connector to secure the cable.
4 Replace the screw (M2.5x2.5) that secures the sensor board to the display
panel.
Post-requisites
1 Follow the procedure from step 4 to step 6 in
2 Replace the display
3 Replace the battery.
4 Replace the base
94
computer. After working inside your computer, follow
After working inside your
assembly.
cover.
computer. For more safety best
www.dell.com/
"Replacing the display
Before
panel".