Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1. Align the screw hole on the sensor board with the screw hole on the display-panel assembly and snap the sensor board in
place.
2. Slide the sensor-board cable into the connector on the sensor board and close the latch to secure the cable.
3. Adhere the tape on the sensor-board connector to secure the cable.
4. Replace the screw that secures the sensor board to the display-panel assembly.
Post-requisites
1. Follow the procedure from step 5 to step 6 in
2. Replace the
display
assembly.
3. Replace the battery.
4. Replace the
base
cover.
80
Replacing the sensor board
Replacing the sensor board
computer. After working inside your computer, follow the instructions in
"Replacing the display
panel".
48
After
www.dell.com/
Advertisement
Table of Contents
