Replacing the sensor board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Align the sensor board on the display-panel assembly and snap the sensor board
in place.
2
Slide the sensor-board cable into the connector on sensor board and press down
the latch to secure the cable.
3
Adhere the tape that secures the sensor-board cable to the sensor board.
4
Replace the screw (M2x2 Big Head) that secures the sensor board to the
display-panel assembly.
Post-requisites
1
Follow the procedure from step 6 to step 8 in
2
Replace the
display
3
Replace the
wireless
4
Replace the battery.
5
Replace the
base
106
computer. After working inside your computer, follow
After working inside your
assembly.
card.
cover.
computer. For more safety best
www.dell.com/
"Replacing the display
Before
panel".