Suzuki IGNIS 2022 Series Manual page 246

EXAMPLE
2) Push the brightness control switch (2)
up or down to select "TPMS" and push
the information switch (1).
NOTE:
If you exit the setting mode, select "Back"
and push the information switch (1).
EXAMPLE
75RM321
3) Push the brightness control switch (2)
up or down to select "Tyre Press" and
push the information switch (1).
EXAMPLE
4) The display shows current tyre pres-
sure.
OPERATING YOUR VEHICLE
NOTE:
• If the low tyre pressure warning light
comes on, the information display will be
switched to "Tyre Press" display and the
corresponding tyre pressure indication
blinks to alert you which tyre(s) is(are)
low pressure.
• The display may not show the tyre pres-
sure for about 10 minutes after the vehi-
cle begins to move. This is because the
TPMS system learns the tyre pressure
within this 10 minutes. The display will
show the tyre pressure after 10 minutes
passed.
• If you stop the vehicle and turn the igni-
75RM332
tion switch to "LOCK" position or change
the ignition mode to LOCK (OFF), and
leave it for 20 minutes or more, tyre
pressure will be reset and will be indi-
cated as 0 kPa when the engine is
restarted. In this case, the current tyre
pressure indication will recover after
driving for a while. However, if any of
tyre pressures has been detected as low
pressure before stopping the engine, the
tyre pressure indication may not recover
and may be indicated as "---".
75RM333
3-84