Suzuki IGNIS 2022 Series Manual page 245

OPERATING YOUR VEHICLE
TPMS limitations
The tyre pressure monitoring system may
not function properly under certain circum-
stances. In the following situations, the low
tyre pressure warning light may come on
and remain on or may blink.
• When you replace a flat tyre with the
spare tyre.
• When you include a spare tyre during a
tyre rotation.
• When the TPMS sensor is damaged
during a tyre replacement or liquid seal-
ants are used to repair a flat tyre.
• When the TPMS sensor's electronic sig-
nal is disturbed in one of the following
ways:
– Electric devices or facilities using simi-
lar radio wave frequencies are nearby.
– A metallic film that may cause radio
wave interference is attached on the
window.
– A lot of snow or ice covers the vehicle,
in particular, around the wheels or
wheel housings.
– Snow tyres that are not installed with
genuine TPMS sensors or snow
chains are used.
• When you use non-genuine SUZUKI
wheels or tyres.
• When the pressure of any tyre is too
high.
• When there is a problem with the
receiver of the TPMS controller.
3-83
TPMS setting
• For the instrument cluster with tachome-
ter, you can check the current tyre pres-
sure on the information display.
• You can set one of the initial value of tyre
pressure below that is indicated on the
tyre information label.
– Comfort Mode (Unladen Mode)
– Load Mode (Laden Mode)
WARNING
When the loading
changed, adjust the tyre pressure
according to the tyre information
label and set the initial value via the
information display. If the loading
weight, tyre pressure and initial value
do not match, the tyre pressure moni-
toring system will not function prop-
erly.
To check the current tyre pressure
(instrument cluster with tachometer)
EXAMPLE
weight has
(1)
1) When the ignition switch is in "ON"
position or the ignition mode is ON and
the vehicle is stationary, push and hold
the information switch (1) for more than
3 seconds to change the information
display to the setting mode.
(2) (1)
75RM184