B8 - Greasing With Wieland Rings; B9 - General Greasing - Manitou MSI 20 D Operator's Manual

- Then block the lock nut 2 (Fig. B7) and the nut 3 (Fig. B7).
- Retighten the nut 1 (Fig. B7).
These checks are important for the good working operation of the mast.
In case of technical faults, consult your dealer.
B8 - G
REASING WITH WIELAND RINGS
Clean and lubricate the following points with grease (See chapter :
LUBRICANTS AND FUEL in paragraph : 3 - MAINTENANCE) and remove
the surplus of grease.
1 - Lubricators of the articulation axles at the foot of the mast 1 (Fig.
B8/1) (2 lubricators).
2 - Lubricators of the foot axles 2 (Fig. B8/2) of the tilt cylinders (2 lubri-
cators).
NOTE : Lift up the overhead guard or the cabin (See chapter : INSTRU-
MENTS AND CONTROLS) in paragraph : 2 - DESCRIPTION).
B9 - G
ENERAL GREASING
Clean and lubricate the following points with grease (See chapter : LUBRICANTS AND FUEL in paragraph : 3 -
MAINTENANCE) and remove the surplus of grease.
1 - Lubricators of the head axles 1 (Fig. B9/1) of the tilt cylinders (2 lubricators).
2 - Lubricators of the head axles 2 (Fig. B9/2) of the steering cylinder (2 lubricators).
3 - Lubricators of the swivel pins 3 (Fig. B9/3) (4 lubricators).
4 - Lubricators of the oscillation axle of the hind carriage 4 (Fig. B9/4) (2 lubricators).
5 - Lubricators of cabin door 5 (Fig. B9/5) (Cabin model) (4 lubricators).
B9/1
1
B9/2
2
3 - 15
B8/1
1
B8/2
2
B9/3
3
3