Switching Automatic Table Feed On/Off; Switching The X - Y - Z Axis Feed On; Switching The X - Y - Z Axis Feed Off; Y - Z Axis Rapid Traverse - Optimum OPTImill MZ 4 Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
4.11

Switching automatic table feed on/off

4.11.1 Switching the X - Y - Z axis feed on

ATTENTION!
Loosen clamping lever on the cross table.
Loosen clamping lever on the milling head.
INFORMATION
The coupling lever only remains in the selected
position if the continuously variable feed rate is at
"0".

Set feed rate to "0".

Switch on drive motor for the feed.

Set coupling lever X, Z or Y in the required feed direc-
tion.

Slowly increase the feed rate.

4.11.2 Switching the X - Y - Z axis feed off


Set feed rate to "0".

Switch off drive motor for the feed.

Set coupling lever in the neutral position.
4.11.3 X - Y - Z axis rapid traverse

Loosen clamping lever.

Set feed rate to "0".

Switch on drive motor for the
feed.

Move lever to the required
direction.

Operate the push-button on
the control panel.
GB MZ4 │MZ4V
Page 42
0
Coupling lever
Y axis
Clamping lever
Coupling lever
X Z axis
Original operating instructions
+Z
+Y
+X
Version 1.0.1 dated 2016-02-23
Operation