Activate / Deactivate Automatic Table Feed; Switching The X - Y - Z Axis Feed On; Switching The X - Y - Z Axis Feed Off; Y - Z Axis Rapid Traverse - Optimum Optimill MZ 4S Operating Manual

4.11

Activate / deactivate automatic table feed

The feed drives consist of a universal helical gear and an inverter motor in each axis. The feed
force is 1600 N with a continuously adjustable feed from 0.05 metres per minute to 0.45 metres
per minute. The rapid traverse speed is 0.78 metres per minute.

4.11.1 Switching the X - Y - Z axis feed on

ATTENTION!
Loosen clamping lever on the cross table.
Loosen clamping lever on the milling head.

Set feed rate to "0".

Switch on drive motor for the feed.

Set the direction lever X, Z or Y in the desired
feed direction and engage.

Slowly increase the feed rate.

4.11.2 Switching the X - Y - Z axis feed off


Set the feed direction lever to the neutral position.

Switch off drive motor for the feed.

Set feed rate to "0".
4.11.3 X - Y - Z axis rapid traverse

Loosen the clamping lever.

Switch on drive motor for the feed.

Set the direction lever in the desired direction.

Operate the push-button on the control panel.
GB
MZ4S
42 Translation of the original instructions
+Z
+Y
+X
0
0
Version 1.0.4 - 2020-07-31
Operation