Attaching Driver To Base Plate - Shaver HD-8-S Operator's & Parts Manual

NOTE: Hydraulic base plate installation is
shown. Installation of manual base plate is
similar.
1. Remove the carriage bolts, washers, and
nuts from hydraulic base plate. Save the
hardware for reuse.
2. Install hydraulic base plate on three- point
hitch weldment, as shown. Install carriage
bolts, washers, lock washers, and nuts
removed in Step 1. Center the base plate on
the three-point hitch and tighten the hardware
securely.
3. Install hydraulic cylinders on hydraulic base
plate, along with scissor stop assembly as
shown below. Secure
(included).
C
F
NOTE: Side tilt cylinder (A) is secured with
cylinder mounting pins (D). Forward tilt cylinder
(B) and scissor stop assembly (C) are
secured with cylinder mounting pin (E) and
channel mounting pin (F). Install supplied cotter
pins in both ends of all mounting pins.
with cotter pins
D
A
D
E
B
The
Assembly is tall and heavy. To avoid
tip over, resulting in serious injury
or death, leave the overhead lifting
device
Carriage Channel while assembling
components.
B
A
Proper lifting device (large arrow above) when attaching
Driver to Base Plate.
Attaching the Driver to Base Plate.
a. Position and align Driver with lower base
plate pivot location (A above). Install the pin
and secure with included cotter pins.
b. Manually extend Forward Tilt Cylinder, align
and install upper mounting pin (B above) and
scissor stop safety lever (C above). Make
sure scissor stop safety lever (C above) is
installed on upper mounting pin (B above).
Secure with included cotter pins.
NOTE: If using Manual Base Plate Assembly,
17
Main Carriage
attached to the
C
Channel
Main