Stabilizer Legs; Base Plate - Shaver HD-10 Operator's Manual

Stabilizer Legs

1. Place three-point hitch weldment (K1)
upside down on the floor. Install stabilizer
leg brackets (K2), with stabilizer legs (K7)
installed, over the cross tube, as shown.
Tighten two leg bracket bolts (K3) to secure
the brackets to the cross tube.
(K1) Three-Point Hitch Weldment. (K2) Leg Bracket.
(K3) Leg Bracket Bolt. (K7) Stabilizer Leg.
2. Set stabilizer leg (K7) height at 8" (20.3 cm)
measured from three-point hitch weldment
(K1) cross tube to the stabilizer leg base
plate, as shown. Tighten the stabilizer leg
lock bolts.
(K1) Three-Point Hitch Weldment. (K2) Leg Bracket.
(K7) Stabilizer Leg.
NOTE: If a different set of holes was used to
mount channel bracket (D1 or D2), the height
of the legs will need to be adjusted
accordingly.
3. Turn over three-point hitch weldment (K1)
and set it on stabilizer leg (K7) base plates,
as shown.
(K1) Three-Point Hitch Weldment. (K7) Stabilizer Legs.

Base Plate

NOTE: Hydraulic base plate (F2) installation is
shown. Installation of manual base plate (E2)
is similar.
IMPORTANT NOTICE
Hydraulic system fittings that require a thread
sealant must be installed with a paste-type
sealer only. Do not use a tape-type sealer, such
as Teflon Tape, as this can contaminate the
system and voids the valve warranty.
1. Remove the carriage bolts, washers, and
nuts from hydraulic base plate (F2). Save
the hardware for reuse.
10