Triple Lever Control Valve For Hydraulic Base Plate - Shaver HD-8-S Operator's & Parts Manual

5. Attach the hoses as follows (see above).
Screw in one end of the 3/4 x 48" hose (item
5) to the 45° fitting in the 'B' working port on
top of the valve and the other end to the port
on the driver cylinder using paste-type
thread sealant on the fittings. The 1/2 x 120
hose (item 3) connects to the 90° fitting in the
'IN' pressure port on the top of the valve and
the other end is hooked up to the pressure
hydraulic line from tractor. The 3/4" x 120
Return line hose is screwed into the 90°
fitting from the 'OUT' port of the valve using
paste-type thread sealant on the fitting.
6. For the other end of the return hose use the
appropriate adaptor listed for you tractor in
the TRACTOR LISTING spread sheet (see
below) using paste-type thread sealant on
the fitting.
Return line and adaptor (SM-10-R Adaptor is shown).
IMPORTANT: For the Driver to function
properly the return line must be connected
directly to the hydraulic reservoir of the tractor
or skid loader.
IMPORTANT NOTICE
The hydraulic valve and cylinder(s) can be
damaged by contamination (dirt and debris)
from the oil in the tractor or power source.
Ensure the oil is clean and properly filtered
before connecting the Post Driver to a
hydraulic power source. Failure to follow oil
cleanliness standards voids the
Post Driver warranty.
Triple Lever Control Valve for Hydraulic Base
Plate
1. Remove the plugs from the hydraulic control
valve.
7
8
Hydraulic Tilt Base Control Valve fitting.
19
Shaver
1
10,11
9
2