Mounting Instructions; Rear-Mounted (3-Point); Self-Contained Mounting Package - Shaver HD-8-S Operator's & Parts Manual

5. Align the bushings in the Driver with the
bushings in the Base Plate (see arrows
below). Install Pins and secure with the
supplied cotter pins.
Front mounting of driver in LOWER position, HD-10 shown.
Storage leg heights on 3-point hitch mount.

Mounting Instructions

Rear-Mounted (3-Point Hitch)
1. Place three-point hitch weldment upside down
on the floor.
2. Set storage leg height 'X' measured from
three-point hitch weldment mounting angles to
the storage leg base plate, as shown. Tighten
the storage leg lock bolts.
a. For UPPER Base Plate mounting position set
'X' at 45" (114.3 cm).
b. There is no useable dimension 'X' for storage
legs when diver is in the LOWER Base Plate
mounting position
3. Turn over three-point hitch weldment and
set it on storage leg base plates.

Self-Contained Mounting Package

(Skid-Loader)
1. Remove the plugs from the hydraulic
reservoir, pump, and motor.
2. Place Universal Mounting Bracket (item 1) on
the floor. I nst all t he Reservoir Bracket (item
3) on the outside of the mounting angles on
15
'X'