Shaver HD-8-S Operator's & Parts Manual page 34

over, causing serious injury or even
death.
3. On hydraulic tilt Post Drivers, tighten the nut
on cylinder Scissor Stop bolt (see arrow
below) to prevent the cylinder from drifting
and causing an unstable condition with the
Post Driver.
Cylinder Scissor Stop Bolt.
NOTE: Failure to tighten this bolt could
allow the Post Driver to fall over, causing
serious injury or even death.
4. Make sure all pressure is r e l e a s e d (zero
pressure) from the Post Driver hydraulic
system. Disconnect
supply hose (A) from the tractor or skid
loader. Disconnect hydraulic return hose
(B) from the tractor or skid loader, see below.
D
Hydraulic Pressure Supply Hose (A), Hydraulic Return
Hose (B), Top Link Pin (C), and Lower Lift Arms (D).
hydraulic pressure
C
D
A
B
5. For 3-Point Hitch remove top link pin (C)
from weldment and disconnect top link.
Then disconnect the two tractor lower lift
arms from the lower hitch pins (D) to
separate the tractor three-point hitch from
the Post Driver, see above.
6. Carefully move the tractor or power source
away from the Post Driver.
Service Procedures
To avoid personal injury or death, carefully
read and understand all instructions before
attempting to assemble and/or operate the
P o st Driver. Do not operate or work
on equipment unless you read and
understand
warnings in this and all other
applicable
Shaver Manufacturing Company if any of the
instructions provided are unclear or not
understood.
responsibility. Always follow all State and
Federal health and safety laws and/or local
regulations.
glasses, hearing
gloves, and steel toe footwear.
shut off the machine, set parking brake, and
remove key before performing any service.
immediately.
NOTE: Disassembly,
34
WARNING
the instructions and
manuals.
Proper care
To help prevent personal
injury,
equipment must be worn
during Post
assembly, operation, and
maintenance.
protective
should include, but n o t
b e limited to,
protection,
Before making
adjustments on the Post
Driver, ensure
hydraulic levers are in the
neutral position. Always
Personal injury can result
from slips or falls. DO NOT
leave tools or parts lying
around the work area and
clean up all spilled fluids
assembly,
Contact
is your
protective
Driver
Personal
equipment
safety
protective
any
that all
and/or