Mounting Instructions; Front-Mounted - Shaver HD-8-S Operator's & Parts Manual

Mounting Instructions

Front-Mounted

1. Attach the Mounting Bracket(s) to the
front of the tractor with the bolts provided.
If no bolts are provided, use the bolts in
the frame. Please refer to the individual
instructions supplied with the tractor
mounting kit.
NOTE: Manual base plate installation
shown. Installation of Hydraulic base plate is
similar.
2. Remove the carriage bolts, washers, and
nuts from Manual base plate. A l s o r e m o v e
t h e B a s e P l a t e P i n s a n d t h e c o t t e r
p i n s a t e a c h e n d . Save the hardware
and pins for the next step.
3. Install manual base plate on front mount
adapter as shown. Install
washers, lock washers, and nuts removed in
Step 1. Center the base plate on the three-point
hitch and tighten the hardware securely.
is
carriage bolts,
14
Main Carriage Channel
4. Use a suitable overhead lifting device
(arrow as shown) to raise (stand up) Main
Carriage Channel. Position the Driver in front
of the Base Plate as shown below.
The Main
assembly is tall and heavy. To
avoid
serious injury or death, leave the
overhead lifting device attached
to the Main Carriage Channel
while assembling components.
Carriage Channel
tip over, resulting in