Base Plate - Shaver HD-8-S Operator's & Parts Manual

the Universal Mounting Bracket with two (2)
each 1/2" bolt, lock washer and nut (items 9,
10, & 11). Attach the Pump/Motor/Reservoir
(item 2) by lining up the slots in the
Pump/Motor/Reservoir with slots in the
Universal Mounting
Reservoir Bracket, then secure four (4) each
3/8" bolt & lock nut and eight (8) flat washer
(see below).
OH-200 - Self-Contained Mounting Package Assembly.
Item Qty. Part No.
1 1 MBS-77-20
2 1 OH-101-1
3 1 OH-101-2B
4 1 SM-0252-R
5 1 300340
6 3 SM-1022-P
7 1 CT-832-MC
8 1 CT-832-FC
9 2 300326
10 2 300101
11 2 300102
12 4 300189
13 8 300178
14 4 300181
Bracket and
DESCRIPTION
Bracket Assy., Universal Mtg.
Pump/Motor Kit, Complete
Frame Weldment, Reservoir Bracket
Hose Assy., Hyd. 3/4" x 48" 3/4" MNPT
Bushing, Reducer 1" NPT x 3/4" NPT
Hose Assy., Hyd. 1/2" x 54" 1/2" MNPT
Coupler, 1/2" Male Flat Face
Coupler, 1/2" Female Flat Face
Screw, Cap 1/2 -13 x 3 Hew Head Gr5 Zn
Washer, Lock 1/2 Zn
Nut, Hex 1/2-13 Zn
Bolt, Tap 3/8-16 x 1" Gr5 Zn
Washer, Flat 3/8 Std. Zn
Nut, Lock 3/8-16 Zn
IMPORTANT NOTICE
the
The following hydraulic fittings and hoses
require a paste type sealer. Do not use a tape-
type sealer, such as Teflon Tape, as this can
contaminate the system and voids the valve
warranty.
3. Install hoses as follows (see above). Screw in
the Bushing Reducer (item 5) into the open
port on the top of the tank next to the breather
cap, then screw in one end of the 3/4" x 48"
hose (item 4) into the Bushing Reducer. The
other end of the hose goes to the 90° fitting in
the 'T' port on the hydraulic control valve.
4. A 1/2" x 54" hose (item 6) connects to the 45°
fitting in the hydraulic pump and the other end
attaches to the 90° fitting in the 'P' pressure
port on the top of the hydraulic control valve.
5. The other two (2) 1/2" x 54" hoses (item 6)
connect to the 90° fittings in the hydraulic
motor and the other ends attach to the Quick
Couplers (item 7 & 8). The Female Coupler
(item 8) connects to the hose going to the
check valve on the hydraulic motor. The Male
Coupler attaches to the other hose connected
to the hydraulic motor.
6. The Self-Contained Mounting Package should
look similar to below when completed.
OH-200 - Self-Contained Mounting Package completely
assembled.
Base Plate (Hydraulic or Manual)
16