Storage - Shaver HD-8-S Operator's & Parts Manual

hydraulic control valve levers a few times, to
remove air from the hydraulic system.

Storage

For best results, always store equipment in a
dry, protected location. Leaving equipment
unprotected will shorten the service life of the
implement.
1. Before storing, remove debris and
clean the entire unit with compressed air
or pressure washer.
2. Inspect the Shaver Post Driver. Replace
any worn or damaged parts before using
the Post Driver again.
• Check all bolted connections. Ensure
that fasteners are tight, and all pins are
secured in place.
• Inspect frame for structural fractures.
• Make sure all warning decals are in place
and legible.
• Make sure rubber debris guard is in place
and in good condition.
• Check hydraulic cylinder(s) for signs
of seal damage or excessive wear.
• Inspect all hydraulic hoses and fittings for
leaks or signs of wear.
3. After cleaning, lightly lubricate guide
blocks with clean engine oil. Do not apply
grease, as this will retain grit and cause
excessive wear.
4. Clean and lubricate hydraulic control valve
safety stop linkage. Make sure return
spring and cotter pins are in good
condition.
5. Apply a light coating of clean grease to all
exposed hydraulic cylinder shafts to help
prevent rust.
6. On SHD-10 and HD-12-H-S Hydraulic Base
Plate grease the two (2) lubrication fittings.
42