Safety Arm Assembly - Shaver HD-8-S Operator's & Parts Manual

SHD-10 Rubber Debris Guard mounting.
3. For SHD-10 attach the Rubber Guard and
Caution Tag on drive ram, with guard
mounting hardware, three (3) 3/16" x 3/8
blind rivets, as shown above.
NOTE: To avoid damage to the Rubber Debris
Guard, do not over-tighten the mounting
hardware.

Safety Arm Assembly

To avoid serious injury or death,
the safety arm must be installed
after the Post Driver has been
mounted on
t h e freestanding Post Driver
has been secured to prevent
tipping.
1. Locate safety arm assembly parts and
hardware.
a machine, or
Safety Arm Mounting holes (HD-10 with manual base plate
shown).
2. Locate the set of two (2) mounting holes in the
Stabilizer Channel to be used to attach the
Safety Arm.
Safety Arm Mounting Bracket in Upper Position (HD-10
with Manual Base Plate shown).
3. Attach safety arm frame to inside of stabilizer
channel with two (2) 3/4-10 x 2" bolts and self-
locking nuts, as shown above. Tighten nuts
securely.
22
UPPER
LOWER