Basic Operation - Labnet 222DS Instruction Manual

4 | 222DS BENCHTOP SHAKING INCUBATOR

6.2. Basic Operation

Press POWER switch on control panel. Shaking incubator automatically detects power supply frequency
F50 or F60 and shows it on display. Likewise the shaking incubator is then set to last saved parameters.
POWER
Press and hold encoder knob for more than 2 seconds. Temperature signal light blinks. With rotating
encoder clockwise (+) or counter-clockwise (-), set temperature to desired value:
POWER
If you want to use the shaking incubator without temperature regulation set OFF on display. You get
OFF function on display, when you rotate encoder under 0.0°C or above 70.0°C.
POWER
Press encoder knob.
Speed signal light blinks. With rotating encoder clockwise (+) or counter-clockwise (-), set rotating
speed to desired value:
POWER
RUN
88.8
TEMP
SPEED F50
TIME
37.5 = 37.5°C
RUN
37.5
TEMP
SPEED
99.5
TIME
RUN
37.5
TEMP
SPEED
OFF
TIME
34 = 34 rpm
120 = 120 rpm
RUN
37.5
TEMP
SPEED 120
TIME
START
Encoder
STOP
START
Encoder
STOP
START
Encoder
STOP
START
Encoder
STOP