Operating Instructions; Control Panel - Labnet 222DS Instruction Manual

6.0 Operating Instructions

6.1. Control Panel

1
POWER
1. POWER key – switch ON (illuminates when on) or OFF.
2. RUN – green signal light illuminated when shaking incubator is running.
3. TEMPERATURE – yellow signal light illuminated when the shaking incubator is set on temperature.
4. SPEED – yellow signal light illuminated when the shaking incubator is set on speed.
5. TIME – yellow signal light illuminated when the shaking incubator is set on time.
6. ENCODER – by rotating the encoder clockwise (+) or counter clockwise (-) you can change the Time,
Speed and Temperature on the shaking incubator. Push encoder to change between Time, Speed and
Temperature. If you rotate encoder knob fast, the value on display goes up and down quickly.
7. START/STOP key – START or STOP operating.
8. TEMPERATURE display.
9. SPEED/TIME display.
2 3
RUN
88.8
TEMP
SPEED
88.8
TIME
5 4
8 6 7
START
Encoder
STOP
9
Instruction Manual | 3