Labnet ProBlot Rocker 25 Instruction Manual

4.0. TROUBLESHOOTING GUIDE / SERVICE
Be sure to disconnect the rocker from the main power source immediately in case of
any signs of malfunction and contact Labnet International, Inc. Service Department at
(732) 417-0700; Monday through Friday; 8.30a.m. - 5.00p.m.; EST.
Problem
POWER switch doesn't light up
Rocker does not START
5.0. ROUTINE MAINTANCE / CLEANING
• No routine maintenance or lubrication is required.
• It is recommended that the rocker is kept clean to insure long trouble-free operation.
5.1. CLEANING
The outside housing can be cleaned with a soft, damp cloth when needed.
Do not use any aggressive or abrasive cleaners (acetone, nitro, polish etc.) This may
permanently damage the rocker finish.
Before cleaning the rocker, always unplug the power cord from the
!
wall socket!
NOTE :
Misuse or unauthorized modifications will waive the warranty rights. If the equipment is used in
a manner not specified by the manufacturer, the safety features of the shaker may be impaired.
P.O. Box 841 • Woodbridge, NJ 07095 • phone: 732 417-0700
e-mail: labnet@labnetlink.com • http://www.labnetlink.com
Explanation / Solution
Check the power connection, Check fuses
Call Labnet Service Department
Check the power connection, Check fuses
Call Labnet Service Department
1. Set posts (A) through four holes at
the corners of bottom platform
2. Add washer (B) and nut (C) to each
post.
3. Fit upper platform (D) on the top of
four posts through corner holes.
4. Screw on four metal knurl nuts (E)
to secure upper platform.
Instruction Manual
ProBlot
ProBlot
Rocker 25
Rocker 25
and 25XL
25XL
Labnet International, Inc.
PO Box 841
Woodbridge, NJ 07095
Phone 732 417-0700
Fax 732 417-1750
email labnet@labnetlink.com
www.labnetlink.com
October 2008