Basic Operation - Labnet Orbit S2020-P4-B Instruction Manual

5.2. Basic Operation

Press the POWER switch on control panel. The Labnet Orbit™ Digital Shaker automatically detects supply frequency of 50 or 60Hz,

and displays F50 or F60.
Then the display switches to show the set time and illuminates the Time light.

Time signal light is on. By rotating the encoder knob right (+) or left (-) the set time can be selected from 30 sec. to 99 min. 50 sec.:

99.5 = 99 min. 50 sec.
•
9.59 = 9 min. 59 sec.
•
0.30 = 30 sec.
•
If you want to set the timer to Hold, turn the knob left or right until "HLd" is displayed.
You can reach the "HLd" function by setting to under 0.30 or above 99.5.
Push the encoder knob to switch modes between time set mode and RPM set mode. RPM signal light is on. By rotating the encoder

knob right (+) or left (-) the desired RPM can be selected:
34 = 340 rpm
•
120 = 1,200 rpm
•
POWER
RUN TIME
F50
POWER
RUN TIME
99.5
POWER
RUN TIME
HLd
POWER
RUN TIME
120
RPM
Encoder
Push
RPM
Encoder
Push
RPM
Encoder
Push
RPM
Encoder
Push
START
STOP
START
STOP
START
STOP
START
STOP
Instruction Manual | 5