Table of Contents
Advertisement
Overview – Before using the unit
Before using the unit
Before using the unit, always check if the built-in battery is not consumed, and then
set the date/time.
The date of the internal clock of the unit resets to January 1, 2022 if the built-in battery is exhausted. This may result in the meta
data of the clip not being recorded correctly, and it may not display correctly in the thumbnail screen.
Connect the AC adaptor to the main unit or attach a battery when recharging the built-in battery.
The date/time set on the main unit is maintained for approximately 4 months when left in this state for approximately 24 hours.
(Recharged even when the power is on.)
•
For details about setting the time zone and date/time (
Do not use the unit in oily-smoky or dusty places.
Performance may be adversely affected if small particles or other foreign objects get inside the product.
Take extra care in environments where a special effect such as theatrical smoke is used.
When using this product during rain or snow or when at the beach, be careful that
water does not get inside the camera.
Water causes damage to the camera and memory card. (Repair may be impossible)
Take care so sand and/or dust do not get inside the camera when using it at the beach,
etc.
Sand and dust may damage the camera and memory card. (Be careful when inserting or removing the memory card)
AC adaptor, battery charger, and battery
•
It may take more time to charge or may not be able to charge when the temperature of the battery is extremely high or
extremely low.
•
When the charging lamp continues to flash in orange, check if there is any debris, foreign object, or dirt attached to the
terminal section of the battery or the battery charger, and reconnect it correctly. Always disconnect the power plug from the
power outlet before removing the debris, foreign object, or dirt attached to the terminal section.
•
The charging lamp will flash in orange when the temperature of the battery is extremely high or low.
Then, charging will start automatically after the battery reaches chargeable temperature.
•
If the charging lamp continues to flash in orange even when the battery is at its optimal temperature, the battery or battery
charger may be damaged. Consult the dealer.
•
Noise may be generated in radio when the unit is used close to a radio (especially when receiving AM). Keep a distance of
1 m (approx. 3.3 feet) or more when using.
•
Oscillating sound may generate inside the AC adaptor or the battery charger during the use, but this is not a malfunction.
•
Always disconnect the power plug from the power outlet after the use. (Power of approximately 0.1 W is consumed by the AC
power itself if kept connected)
•
Do not get the terminal section of the AC adaptor, the battery charger, or the battery dirty. Install the device close to the power
outlet so the disconnection device (power plug) can be easily reached.
Memory cards
•
The surface of this unit or the memory card may get slightly hot when used for a long period of time, but this is not a
malfunction.
•
The amount of memory included on the label of the memory card is the total amount of memory below.
– Capacity to protect and manage copyright
– Capacity usable as the normal memory on the unit or a PC.
•
Do not give a strong impact to, bend, or drop the memory card.
•
Memory card data may become destroyed or erased in the following cases.
– Electrical noise or static electricity
– Malfunction of the unit or the memory card
•
Do not perform the following operations when accessing the memory card (the card 1 access lamp/card 2 access lamp is
flashing in orange).
– Removing the memory card
– Disconnecting battery or the AC adaptor without turning off the main unit
– Apply vibration of impact
[TIME ZONE]:
25,
[CLOCK SETTING]:
10
25).
Advertisement
Table of Contents
