Table of Contents
Advertisement
Network Connection – Streaming function
RTSP
Start the streaming with an operation of the application software or device at the receiving side (referred to as "receiving side"
hereinafter).
1
Select the [NETWORK] menu
[RTSP].
2
Set the standby port with the [NETWORK] menu
[LISTEN PORT] on the camera if required.
3
Specify the IP address and the path of the camera as following on the receiving side,
and start streaming.
rtsp://(IP address):(Port number)/stream
•
Stop the streaming with the operation in the receiving side.
•
For details about the operations to start streaming from the application software, please see the manual for the application
software.
•
Streaming cannot be started while the thumbnail screen is displayed.
Streaming with multicast
One streaming can be distributed to multiple receivers via supported router, etc., when the multicast function is used.
1
Select the [NETWORK] menu
[ENABLE].
2
Select the [NETWORK] menu
[MULTICAST ADDRESS] and [MULTICAST PORT].
•
Set [MULTICAST ADDRESS] within following range.
– IPv4: 224.0.1.0 to 239.255.255.254
– IPv6: Multicast address starting with FF
•
Set [MULTICAST PORT] within the range of 1024 to 50000.
3
Specify the address of the unit and start streaming with the application software.
•
Depending on the specification of the device receiving streaming and the connected router, quality of the video image may
not be preserved. When streaming by multicast, contact the administrator of the network being used and prepare
appropriate communication environment.
•
Disable the LAN card not to be used when receiving the multicast image to be displayed on a computer with multiple LAN
cards installed.
•
Range of streaming can be adjusted with the [NETWORK] menu
LIMIT]. For details, contact the network administrator.
[STREAMING]
[STREAMING PROTOCOL]
[STREAMING]
[STREAMING]
[RTSP SETTING]
[STREAMING]
[RTSP SETTING], and specify
[STREAMING]
284
[RTSP SETTING]
[MULTICAST]
[RTSP SETTING]
[TTL/HOP
Advertisement
Table of Contents
