Table of Contents
Advertisement
Parts identification and handling
Using the hand strap (supplied)
Using as strap
Using as a grip belt
Screw the adaptor hanging from
the strap into the tripod hole.
Attaching the float
The float prevents the unit from sinking
when it is accidentally dropped into water.
●
Cleaning the float after use (P.19)
Using the LCD monitor
Images can be checked on the LCD monitor when recording.
Open the LCD monitor.
Hold [ ] to
open.
●
Opening the LCD monitor beyond the mechanical limit or turning it more than
90 ˚ may allow water to enter and damage the mechanism.
●
Brightness and color density can be adjusted. (P.31)
16
VQT2A17
(cont.)
Fit over your wrist and adjust the
length of the strap.
Fit over your hand and adjust the
length of the strap.
Attach the float here.
Adjust the angle.
Up to 90 ˚
Up to 90 ˚
"Before using the unit under water"
(IMPORTANT) Waterproof performance
Waterproof performance
The waterproofing and dustproofing of this unit comply with IP58 of IEC 60529 "Degrees
of protection provided by enclosures (IP Code)". The unit passed waterproofing tests
(IEC 60529), in which it was submerged to a depth of 2.0 m (6.5 feet) for 30 minutes,
and dustproof tests (IP Code: IP58) in accordance with Panasonic standards, but this
does not guarantee that the unit will not be damaged or malfunction by contact with
water and dust. (The supplied AC adaptor and battery are not waterproof.)
This unit can be used underwater, but care should be taken as improper
handling may cause water to enter the unit and result in malfunction and
loss of SD card data. Read the following carefully before using the unit.
The penetration of water into the unit due to mishandling by the user is not covered by
the guarantee given for the unit's waterproof performance. If water should penetrate
the unit, stop using the unit, and consult the dealer from whom you purchased the unit.
Handling
•
Do not leave the unit in locations where the
temperature exceeds 40 °C (104 °F) (such as
places exposed to strong sunlight, car interiors
on hot days or locations near heating equipment,
in particular) for extended periods of time. (Doing
so could degrade its waterproof performance.)
•
The waterproof performance of the unit cannot
be guaranteed if it is exposed to impacts, such
as being bumped or dropped. If the unit is
deformed by an impact, refrain from using it underwater and contact Service
Center to have its waterproof performance checked (charges apply).
•
Do not plug the unit in or unplug it with wet hands.
•
The unit's waterproof performance is effective only in fresh and saltwater.
Opening and closing the card/battery door and terminal cover
•
To open: Lift the flap upright and turn it counter-clockwise until it clicks for
unlocking and then open the door/cover.
To close: Close the door/cover and turn the flap clockwise to the locking
position and then push the flap back flat.
•
Do not open and close the card/battery door and terminal cover with wet
hands or when in or near water.
•
When droplets of water have formed on this unit or on the inside of its doors
or cover, be absolutely sure to wipe them off using a lint-free cloth before
opening or closing the parts concerned.
NG
Over 40 °C
(104 °F)
NG
Locking
position
17
VQT2A17
Advertisement
Table of Contents
