Table of Contents
Advertisement
Network Connection – Network settings
When entering the wireless access point (SSID) manually
1
Select the [NETWORK] menu
2
Select the [NETWORK] menu
3
Select the [NETWORK] menu
set each item as required.
•
For details about the setting items (
either [INFRA(SELECT)] or [INFRA(MANUAL)]:
4
In [NETWORK] menu
access point being connected to.
Setting is completed when the [ENCRYPT KEY] (encryption key, password) is not set.
5
If the [ENCRYPT KEY] is set, enter the password, and select [Enter].
6
Close the menu or return to the level of the [NETWORK] menu.
7
Check the network connection.
Once connected,
is displayed on the screen of the unit.
Setting items for [WLAN PROPERTY] and [WLAN IPv4 SETTING] when set to either [INFRA(SELECT)] or
[INFRA(MANUAL)]
[WLAN PROPERTY]
[WLAN IPv4 SETTING]
•
Depending on your environment, the communication speed may become slower or the wireless access point may not be
available for use.
•
The startup time after turning on the power may be longer due to starting of the network.
•
When changing the settings of [DEVICE SEL], the changes will not be reflected until the unit is restarted. Also, the setting
screen termination may take some time due to the restart of the network service after the setting is changed.
•
ENCRYPTION in WEP is not supported.
•
Some items cannot be set depending on the settings such as [DHCP].
•
When [DHCP] is set to [CLIENT], some of the information acquired automatically with DHCP is displayed in the menu.
For details of the network status, confirm by selecting the [NETWORK] menu
•
All of the IP address, subnet mask, and default gateway must be correctly set.
For details, contact the network administrator.
•
When the default gateway or DNS is not to be used, set to [0.0.0.0].
However, DNS cannot be disabled when [DHCP] is set to [CLIENT].
•
Depending on the network environment, even if [DHCP] is set to [CLIENT], entry of the DNS value manually may be
required. When invalid DNS value is entered in any other cases, the automatic assignment by DHCP will not operate
properly.
[DEVICE SEL]
[WLAN PROPERTY]
[WLAN PROPERTY] and [WLAN IPv4 SETTING] and
Setting items for [WLAN PROPERTY] and [WLAN IPv4 SETTING] when set to
273).
[WLAN PROPERTY]
[ENCRYPTION]
[ENCRYPT KEY]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[PRIMARY DNS]
[SECONDARY DNS]
[WLAN].
[TYPE]
[SSID], enter the SSID of the wireless
[WPA-TKIP], [WPA-AES], [WPA2-TKIP], [WPA2-AES], [NONE]
(Factory setting: [WPA2-AES])
WPA/WPA2 encryption key
(Factory setting: [01234567890123456789abcdef])
Setting the DHCP function
•
[OFF]: Does not use DHCP.
•
[CLIENT]: Automatically acquired with the DHCP.
(Factory setting: [OFF])
IP address of the unit
(Factory setting: [192.168.0.1])
Subnet mask
(Factory setting: [255.255.255.0])
Default gateway
(Factory setting: [192.168.0.254])
Primary DNS server setting
(Factory setting: [0.0.0.0])
Secondary DNS server setting
(Factory setting: [0.0.0.0])
[INFORMATION]
273
[INFRA(MANUAL)].
[STATUS].
Advertisement
Table of Contents
