Replacing Taillights; Servicing The Battery - Toro Wheel Horse 520xi Operator's Manual

4. Push the wire connectors onto the terminals on the
bulb holder.
5. Close the hood.

Replacing Taillights

Specification: Bulb GE 194
Removing the Bulb
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the
ignition key.
2. Remove the two screws securing the lens (Fig. 53).
3
Figure 53
1. Lens
2. Screws
3. Pull the lens out far enough so you can remove the
bulb socket (Fig. 53).
4. Pull the bulb from the socket (Fig. 53).
Installing the Bulb
1. Push a new bulb into the socket (Fig. 53).
2. Install the bulb socket in the lens and push the lens
into the tractor (Fig. 53).
3. Secure the lens with the two screws removed
previously (Fig. 53).

Servicing the Battery

Check the electrolyte level in the battery every 25 hours.
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery case. If the battery
4
1
2
m–3321
3. Bulb
4. Socket
31
terminals are corroded, clean them with a solution of four
parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Battery size: 12 v, 380 Cold Cranking Amps
Removing the Battery
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the
ignition key.
2. Remove the front grill by pulling it outward toward
you.
3. Remove the battery shield (Fig. 54).
1
8
7
Figure 54
1. Negative cable (black)
2. Positive cable (red)
3. Bolt (2)
4. Washer (2)
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
Do not allow metal tools to short between the
battery terminals and metal parts of the
tractor.
6
4
3
5
2
m–5073
5. Locknut (2)
6. Battery shield
7. Hold–down rod
8. Wire tie