How To Test The Module Transmission Performance - ICP DAS USA I-7565 User Manual

In CAN 2.0A: number of CAN ID bits is 11.
In CAN 2.0B: number of CAN ID bits is 29.
4.3

How to test the module transmission performance

The following procedure will guide you to learning how to
transmit/receive CAN messages to/from other devices/PCs by using the I-
7565 converter. Note that users can only employ this test function for the
system if they are using the default communication parameters for the
USB as provided above.
1. Set the Init/Normal switch to the Normal position, which is found at the
back of the I-7565 module.
2. Connect the I-7565's CAN port into the CAN network, which must at
least have one CAN device on the network.
3. Connect I-7565 to PC USB port via a USB cable.
4. The RUN LED on the I-7565 module will be turned on. That means the
I-7565 is working in the operation mode.
5. Run the I-7565 Utility software after there is a wire connection.
6. Select the "Test" tab and click the "Connect" icon on the tool bar in the
I-7565 Utility to configure the PC's USB port, which will be used to
connect to the USB port of the I-7565.
7. Press the "Ok" button. Then the I-7565 Utility will show the test tab in
the window as can be seen in the below figure.
I-7565 USB/CAN Converter User's Manual (Version 1.0, March/2007)
Figure 14: USB port setting
------------- 23