Introduction - Pitney Bowes F612 Operating Manual

Introduction

1. INTRODUCTION
This operator manual describes how to operate the Model F612/F615
Collator as a stand alone unit.
1.1 Safety
General
• Know your equipment, especially how to stop it in the event of an
emergency.
• Never reach into the machine while it is on; always wait until the machine
has come to a full stop.
• Never touch moving parts.
• Keep fingers, long hair, jewellery and loose clothing away from moving
parts at all times.
• Use the equipment only for its intended purpose.
• Don't remove machine covers. Refer servicing to qualified personnel.
Mains Electrical Connection
In some countries the F612/F615 is supplied with a moulded mains lead.
In other countries, or if the supplied lead is not used, the following information
applies:
1. An approved mains lead for the country concerned must be used.
2. The wires in the supplied mains lead are coloured in accordance with
the following code: Green and Yellow -
3. As the colours of the wires in the mains lead of this equipment may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter "E" or by the earth
symbol
The wire which is coloured blue must be connected to the terminal
which is marked with the letter "N" or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter "L" or coloured red.
Blue
Brown
or coloured green or green and yellow.
2
Earth
- Neutral
- Live