Table of Contents
Advertisement
4. OPERATION
4.1 Load paper
1 Make sure that the sheets are well fanned to avoid misfeeds or double
feeds.
2 Align the sheets well to achieve a reliable collating operation and good
stacking result.
3 Make sure that the ink has dried out well.
4 Press the load lever downwards to release the bins.
5 Load the sheets into the bins against the rear side guide.
6 Move the adjustable side guides up against the sheets until there is no
clearance.
7 Raise the load lever to actuate the feed rollers.
4.2 Operating the Collator
1 Set the on/off switch to on position. The counter display will show "HEJ"
to confirm that the collator is OK.
2 Select output mode:
- Offset/straight stacking mode.
- On-line mode.
3 Select stacking mode if set to stacking:
- Straight stacking.
- Offset stacking.
4 Set the adjustable stacker guide (side) to the selected paper size.
5 Set the adjustable stacker guide (length) to the paper size.
6 Press test/calibration button. The collator will adjust the number of bins
used and the paper quality in each bin and is now ready for operation.
Check the result to make sure that it is OK and press start.
If not correct, repeat the test/calibration.
7
Operation
Advertisement
Table of Contents
