Connecting To The Usb Interface - YOKOGAWA WT5000 User Manual

2.3

Connecting to the USB Interface

Notes about Connections
• Be sure to insert the USB cable connector firmly into the USB port.
• If you are connecting multiple devices by using a USB hub, connect this instrument to the USB hub
port that is closest to the port that the controller is connected to.
• Do not connect or remove USB cables from the time when this instrument is turned on until
operation becomes available (approximately 20 to 30 seconds). Doing so may damage this
instrument.
• Before connecting a PC to the USB port for PCs, ground the PC to the same electrical potential as
the instrument.
• Do not connect a device other than a controller (e.g., PC) to the USB port for PCs.
IM WT5000-17EN
1
2
3
4
5
6
7
8
App
Index
2-3