Canon imagePROGRAF iPF710 Manual page 71

Other Problems
Phenomenon
The printer consumes a lot
of ink
A message to check the
Maintenance Cartridge
is not cleared after you
replace the Maintenance
Cartridge
Paper is not cut neatly
Paper cannot be cut
The printer does not go
on
Troubleshooting If You Cannot Print as Expected
Cause
Many full-page color images are
printed.
Head Cleaning B is used often.
You have just finished initial
installation, when more ink is
consumed to fill the system.
The printer has not detected the
new Maintenance Cartridge.
The paper is bent or curled at
the cut position.
Paper rises by the ends of the
cut position before it is cut.
The Cutter Unit is installed
incorrectly.
The blade of the Cutter Unit is
dull.
In the printer driver, No or Print
Cut Guideline is specified in
Auto Cut.
In MAIN MENU, Eject or Manual
is specified in Cutting Mode.
The Cutter Unit is not installed.
The printer is unplugged.
The specified voltage is not
supplied.
71
Corrective Action
In print jobs such as photos, images
are filled with color. This consumes
a lot of ink. This does not indicate a
problem with the printer.
Head Cleaning B consumes a lot of
ink. This does not indicate a problem
with the printer. Unless the printer
has been moved or stored for a long
period or you are troubleshooting
Printhead problems, we recommend
not performing Head Cleaning B, to
the extent possible.
After initial installation or at the first-
time use after transfer, ink flows into
the system between the Ink Tank and
Printhead, which may cause the ink
level indicators to drop to 80%. This
does not indicate a problem with the
printer.
Remove the new Maintenance
Cartridge you have just installed and
insert it again firmly.
Restart the printer.
Straighten out any curling by the edges
of the paper.
Reload the paper correctly.
Install the Cutter Unit correctly.
(→"Replacing the Cutter Unit," User
Manual)
Replace the Cutter Unit.
(→"Replacing the Cutter Unit," User
Manual)
Specify Yes in Auto Cut in the printer
driver.
Specify Automatic in Cutting Mode in
MAIN MENU.
Install the Cutter Unit.
(→"Replacing the Cutter Unit," User
Manual)
Plug the power cord into the outlet, and
then turn on the printer.
Check the voltage of the outlet and
breaker.
(→"Specifications," User Manual)