Canon imagePROGRAF iPF710 Manual page 66

Troubleshooting If You Cannot Print as Expected
Phenomenon
The edges of the paper
are dirty
Cause
The Platen has become dirty
after borderless printing or
printing on small paper.
The paper type as specified
on the printer does not match
the type specified in the printer
driver.
The paper is wrinkled or warped. Straighten out the wrinkles or curls and
A cut line is printed because the
function to reduce cutting dust
has been activated.
The Printhead is set too low.
You are printing on heavyweight
paper or paper that curls or
wrinkles easily after absorbing
ink.
The Ejection Guide is soiled.
66
Corrective Action
Open the Top Cover and clean the
Platen.
(→P.38)
Make sure the same paper type is
specified on the printer as in the printer
driver.
(→"Selecting the Paper Type (Roll),"
User Manual)
(→"Selecting the Paper Type (Sheet),"
User Manual)
Make sure the same paper type is
specified in the printer driver as on the
printer.
1. Hold down the Stop button for a
second or more to cancel printing.
2. Change the paper type in the printer
driver and try printing again.
reload the paper. Do not use paper that
has been printed on previously.
(→P.11)
(→P.18)
If this function is not needed, deactivate
CutDustReduct. through the printer
menu.
(→"Main Menu Settings," User Manual)
In Head Height, choose Automatic.
(→"Adjusting the Printhead Height,"
User Manual)
When printing on Heavyweight Coated
Paper or other paper-based media,
choose a VacuumStrngth setting of
Strong or Strongest. If the paper is
still scratched, try raising the Printhead
higher in Head Height, one level at a
time.
(→"Adjusting the Vacuum Strength,"
User Manual)
(→"Adjusting the Printhead Height,"
User Manual)
When printing on CAD Tracing
Paper or film-based media, choose a
VacuumStrngth setting of Standard,
Strong, or Strongest. If the paper is
still scratched, try raising the Printhead
higher in Head Height, one level at a
time.
(→"Adjusting the Vacuum Strength,"
User Manual)
(→"Adjusting the Printhead Height,"
User Manual)
Clean the Ejection Guide.
(→P.38)