Canon imagePROGRAF iPF710 Manual page 49

Error Messages
Cannot feed paper.
End of paper feed.
Insufficient paper for job
Cause
The paper has come out of the
printer.
A paper jam has occurred.
You are pressing the ▲ button
on the Control Panel and
trying to rewind the roll to the
edge.
The printer has received a print
job longer than the amount of
roll paper left.
49
Responding to Messages
Corrective Action
Remove the paper, press the Load/
Eject button, and reload the paper.
Lift the Release Lever, remove the
jammed paper, and reload paper.
If the error occurs again, turn off
the printer and wait a while before
restoring power.
Release the ▲ button.
Follow the steps below to replace the
roll.
1. Remove the roll.
(→"Removing the Roll from the
Printer," User Manual)
(→"Removing a Roll from the Roll
Holder," User Manual)
2. Load a roll with enough paper left.
(→P.11)
3.If no barcode was printed on the
roll, specify the paper type.
(→"Selecting the Paper Type
(Roll)," User Manual)
4.Specify the paper length, unless a
barcode has been printed on the
roll and you have deactivated the
automatic detection function of the
remaining roll paper.
(→"Specifying the Paper Length
(Roll)," User Manual)
Hold down the Stop button for a
second or more to cancel printing.
Press the Online button to resume
printing.
However, the roll paper will run out
during the print job, and you will not
be able to print all of the document.