Canon imagePROGRAF iPF710 Manual page 57

Other Messages
Error Messages
GARO Wxxxx (x represents a
number)
Problem with Printhead
Cannot print as specified.
Lift the release lever and
replace paper with A4/LTR
(vertical) or larger
Cannot print as specified.
Lift the release lever and
replace roll with 10 in. wide
or larger roll
There is no data.
Cannot adjust band.
Unknown file.
Prepare for parts
replacement.
Parts replacement time has
passed.
Cause
There is a problem with the
print job.
The Printhead nozzles are
becoming clogged.
The loaded paper is too small.
The loaded paper is too small.
The data was lost because of
replotting.
The Printhead nozzles are
clogged.
Highly transparent film is loaded
that cannot be used for feed
amount adjustment.
Invalid data format.
It is almost time to replace
consumables for which service
is required.
It is past the recommended
time to replace consumables for
which service is required.
57
Responding to Messages
Corrective Action
Try printing again, using the correct
printer driver.
It is also possible to continue printing
in this state.
However, you may not be able to
obtain the desired printing results.
If printing is faint, clean the
Printhead.
(→P.44)
Switch to paper A4/Letter (vertical) or
larger.
Load a roll 10 inches wide or larger.
Data for replotting is lost after the
following operations. In this case,
send the print job again.
・ The memory buffer was cleared
from the Control Panel.
・
The printer was turned off.
・ The printer received a new print
job.
Follow the steps below to check the
nozzles.
1. Print a test pattern to check the
nozzles.
(→P.43)
2. Clean the Printhead if the nozzles
are clogged.
(→P.44)
Adjust the feed amount manually.
(→"Adjusting the Feed Amount
Manually," User Manual)
Check the print job and resend it.
If Parts replacement time has
passed. is displayed, you can
continue to use the printer for some
time.
Contact your Canon dealer for
assistance.
Contact your Canon dealer for
assistance.