Canon imagePROGRAF iPF710 Manual page 56

Responding to Messages
Messages Regarding Ink
Error Messages
Ink tank is empty.
Ink insufficient.
Ink Level: Check
No ink tank loaded.
Ink tank error.
Remaining level of the
ink cannot be correctly
detected.
Cause
There is no ink left.
The ink level is low, so you
cannot clean the Printhead.
The ink level is low, so there
may not be enough ink to finish
printing.
Not much ink is left.
There is no Ink Tank of the
indicated color in the printer.
There is a problem with the Ink
Tank.
The Ink Tank in the printer is
incompatible.
Ink level detection cannot work
correctly if you use refill ink
tanks.
56
Corrective Action
Open the Ink Tank Cover and
replace the Ink Tank for which the
Ink Lamp is flashing.
(→P.31)
Press the OK button and replace the
Ink Tank that is low with a new Ink
Tank.
(→P.31)
Press the OK button and replace the
Ink Tank that is low with a new Ink
Tank.
(→P.31)
You can print until the ink runs out
by pressing the Online button.
However, if the ink runs out during
printing, the following situation will
occur depending on the position of
the leading edge when it passes
through the printer.
1. Ink tank is empty. is displayed
and printing stops. Press the Stop
button to cancel printing, or press
the OK button, replace the ink tank
that is low with a new one, and
continue printing. However, note
that because printing is paused,
colors may be slightly different.
(→P.31)
2. Ink tank empty. Canceling
printing of this page. is displayed
and printing stops. After the paper
is ejected, press the OK button and
replace the ink tank that is low with
a new one.
(→P.31)
Prepare a new Ink Tank.
We recommend replacing the Ink
Tank with a new Ink Tank at this
point if you plan to print large-format
or high-quantity jobs.
Load or reload the Ink Tank.
(→P.31)
Replace it with a new Ink Tank.
(→P.31)
Load an Ink Tank specified for use
with the printer.
(→P.31)
The refill ink tank can no longer be
used. See the section "Ink level
detection" in "Disabling Ink Level
Detection" and take the appropriate
action. (→"Ink level detection," User
Manual)