Canon imagePROGRAF iPF710 Manual page 55

Error Messages
The roll is empty.
This type of paper is not
compatible with HP-GL/2.
GL2: Wxxxx The memory is
full. (xxxx is 0501, 0903, or
0904)
GL2: W0502 The parameter
is out of range.
GL2: W0504 This command
is not supported.
Cause
There is no more paper left on
the roll.
The printer has received a HP-
GL/2 print job that cannot be
printed on the paper that has
been advanced.
The printer memory is full.
A parameter specified in a HP-
GL/2 command is out of the
supported range.
The printer has received
an unsupported HP-GL/2
command.
55
Responding to Messages
Corrective Action
Follow the steps below to replace the
used roll with a new roll of the same
type and size.
1. Remove the roll.
(→"Removing the Roll from the
Printer," User Manual)
(→"Removing a Roll from the Roll
Holder," User Manual)
2. Load the new roll.
(→P.11)
3.If no barcode was printed on the
roll, specify the paper type.
(→"Selecting the Paper Type
(Roll)," User Manual)
4.If no barcode was printed on the
roll, specify the paper length.
(→"Specifying the Paper Length
(Roll)," User Manual)
Replace the paper with a type
compatible with HP-GL/2. For details
on paper compatible with HP-GL/2,
refer to the Paper Reference Guide.
(→"Types of Paper," User Manual)
The printer may continue printing, but
the printing quality may be affected.
Check the printing results.
Because the entire print job could not
be received, the printer may not be
able to print the entire original. Check
the printing results.
Check the print job.
Check the print job.