Canon imagePROGRAF iPF710 Manual page 59

Error Messages
Maintenance cartridge full.
No maintenance cartridge.
No Maintenance Cartridge
capacity.
Prepare for maint cart
replacement.
Top cover is open.
Rel lever is in wrong
position.
ERROR Exxx-xxxx (x
represents a letter or number)
Hardware error.
xxxxxxxx-xxxx (x represents
a letter or number)
Cause
The Maintenance Cartridge is
full.
The Maintenance Cartridge is
not installed.
The Maintenance Cartridge
cannot absorb enough ink for
Printhead cleaning or other
operation.
The Maintenance Cartridge is
almost full.
The printer has detected that
the Top Cover is open.
The Release Lever is pushed
back.
An error may have occurred
that requires service.
The last portion of roll paper
was used during a print job, and
paper could not be advanced
because the trailing edge is
taped to the roll.
Fastening tape or the Belt
Stopper has not been removed
inside the Top Cover.
An error may have occurred
that requires service.
59
Responding to Messages
Corrective Action
After confirming that the printer
has stopped operating, replace the
Maintenance Cartridge.
(→"Replacing the Maintenance
Cartridge," User Manual)
Install the Maintenance Cartridge.
(→"Replacing the Maintenance
Cartridge," User Manual)
After confirming that the printer
has stopped operating, replace the
Maintenance Cartridge.
(→"Replacing the Maintenance
Cartridge," User Manual)
You can continue to print, but
prepare a new Maintenance
Cartridge to use when the message
for replacement is displayed.
Open the Top Cover fully, remove
any foreign objects, and close the
Top Cover again.
If the error occurs again, turn off
the printer and wait a while before
restoring power.
Pull the Release Lever forward.
Turn off the printer and wait at least
three seconds before restoring
power.
If the message is displayed again,
write down the error code and
message, turn off the printer, and
contact your Canon dealer for
assistance.
Turn off the printer and remove the
roll before restoring power.
Turn off the printer, open the Top
Cover, and remove the tape or Belt
Stopper before restoring power.
Write down the error code and
message, turn off the printer, and
contact your Canon dealer for
assistance.