Satellite Receiver Control; Satellite Receiver Control Setting - JVC HR-DVS2EU Instructions Manual

SATELLITE RECEIVER CONTROL

Satellite
Receiver
Control Setting
The following procedure is required if you receive satellite
channels through a satellite receiver. Approximately 20 seconds
before the S V timer programming (
HOW IEW
timer programming ( pg. 36) starts, the recorder sets its input
mode to "L-2" and automatically switches the satellite receiver's
channels using the provided Satellite Controller.
Your recorder
Transmitter
Satellite receiver
21-pin SCART cable
(provided)
Back of Recorder
AV2 (L-2) IN/DECODER
pg. 34) or Express
Satellite receiver
Satellite Controller
(suggested locations)
Satellite Controller
SAT CONTROL
Installing Satellite Controller
SITUATE SATELLITE
CONTROLLER
1
Place the Satellite Controller so that the path between
its transmitter and the satellite receiver's remote sensor
is unobstructed.
ATTACH SATELLITE
CONTROLLER
2
Fix securely using the adhesive strip attached on the
back of the Satellite Controller.
MAKE CONNECTIONS
3
Be sure to connect the recorder's AV2 (L-2) IN/DECODER
connector to the satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its
instruction manual.
CONNECT SATELLITE CON-
TROLLER TO RECORDER
4
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
13
EN