Get T Ing St Ar T Ed; Before Installation; Checking The Supplied Accessories; Setting The Voltage Selector Switch - JVC RX-8010PBK Instructions Manual

Get t ing St ar t ed

This section explains how to connect audio/ video components and speaker s to the receiver, and how to connect the
power supply.
Befor e Inst allat ion
Gener al
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locat ions
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚ C and
35˚ C (23˚ F and 95˚ F).
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling t he r eceiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Checking t he Supplied Accessor ies
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
• AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Set t ing t he Volt age Select or Swit ch
Before connections, always do the following first if necessary.
Set the correct voltage for your area with the voltage selector switch
on the rear panel. Rotate the voltage selector using a screw driver, so
the voltage number the voltage mark is set at is the same as the
voltage where you are plugging in the receiver.
220V
230 - 240V
VOLTAGE SELECTOR
Voltage mark
3
110V
127V
Connect ing t he FM and AM Ant ennas
FM Ant enna Connect ions
A
N N
A
T E
A N
7 5
F M IA L
A X
C O
A M
A M
T
O P E X
L O
FM Antenna
Extend the supplied FM antenna horizontally.
ANTENNA
FM 75
COAXIAL
AM
Outdoor FM Antenna Cable
LOOP
AM
EXT
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75 Ω
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector should be connected to the FM 75 Ω
COAXIAL terminal.
Note:
If reception is poor, connect the outdoor antenna.
Before attaching a 75 Ω coaxial cable (the kind with a round wire
going to an outdoor antenna), disconnect the supplied FM antenna.
A
N N
B
T E
A N
7 5
F M IA L
A X
C O
A M
A M
T
O P E X
L O